NHTSA recalls, safety ratings, and consumer complaints for the 2000 Dodge RAM 2500.
NHTSA has not published 5-star crash-test ratings for the 2000 Dodge RAM 2500. New vehicles are often added to the NCAP rating program after initial release; check nhtsa.gov/ratings for the latest status.
Component: ENGINE AND ENGINE COOLING
CERTAIN REPLACEMENT K&N FUEL PERFORMANCE KITS, P/NOS. 57-1509, 57-1511, 57-1511-1, 57-1517, 57-1517-1, 57-1527, AND 57-1530. ALSO, A SMALL PERCENTAGE OF THESE KITS WERE SOLD UNDER THE MOPAR PERFORMANCE PARTS BRAND NAME (P/NOS. P5007069 AND P5007070). ALL KITS WERE MANUFACTURED FROM APRIL 20, 1999, THROUGH SEPTEMBER 23, 2004. THESE ASSEMBLIES WERE MANUFACTURED AS REPLACEMENT EQUIPMENT FOR CERTAIN DODGE PICKUP TRUCKS AND SUVS. A SMALL PIECE OF MATERIAL FROM THE TUBE WALL COULD BE SUCKED INTO THE ENGINE THROTTLE BODY, WHICH COULD CAUSE THE THROTTLE TO BECOME JAMMED IN THE OPEN POSITION.
Consequence: A JAMMED OPEN THROTTLE COULD CAUSE UNINTENDED ACCELERATION OF THE VEHICLE, POSSIBLY RESULTING IN A CRASH OR INCREASED STOPING DISTANCES WHEN BRAKING.
Remedy: K&N WILL PROVIDE OWNERS WITH A FREE REPAIR KIT ALONG WITH REPAIR INSTRUCTIONS. THE RECALL BEGAN ON APRIL 20, 2006.
Component: AIR BAGS
VEHICLE DESCRIPTION: PICKUP TRUCKS. SOUND DEADENER MATERIAL INSIDE THE STEERING WHEEL COULD BECOME DETACHED FROM THE COVER AND HOUSING. NOTE: THE RAM PICKUP TRUCKS WERE BUILT AT THE WARREN ASSEMBLY PLANT ("S" IN THE 11TH VIN POSITION) FROM MAY 16, 2000 THROUGH OCTOBER 23, 2000; ST. LOUIS NORTH ASSEMBLY PLANT ("J" IN THE 11TH VIN POSITION) FROM MAY 19, 2000 THROUGH OCTOBER 23, 2000; LAGO ALBERTO ASSEMBLY PLANT ("M" IN THE 11TH VIN POSITION) FROM MAY 23, 2000 THROUGH OCTOBER 23, 2000; AND SALTILLO ASSEMBLY PLANT ("G" IN THE 11TH VIN POSITION) FROM MAY 23, 2000 THROUGH OCTOBER 23, 2000. IMPORTANT: VEHICLES THAT HAVE ALREADY HAD THE PROPER CLOCKSPRING INSTALLED, ACCORDING TO WARRANTY RECORDS, HAVE BEEN EXCLUDED FROM THIS RECALL. IN ADDITION, 1997-2000 MODEL YEAR VEHICLES THAT HAVE HAD A SUSPECT REPLACEMENT CLOCKSPRING INSTALLED, ACCORDING TO WARRANTY RECORDS, HAVE BEEN ADDED TO THIS RECALL.
Consequence: WHEN THIS OCCURS, THE MATERIAL COULD INTERFERE WITH THE CLOCKSPRING RIBBON AND CAUSE AN OPEN CIRCUIT. THE DRIVER AIR BAG SYSTEM WILL BECOME DISABLED, AND THE AIR BAG WARNING LAMP WILL ILLUMINATE ON THE INSTRUMENT PANEL.
Remedy: DEALERS WILL REPLACE THE CLOCKSPRING ASSEMBLY. OWNER NOTIFICATION BEGAN JUNE 18, 2001. ALSO SOME 1997-200 MODEL YEAR VEHICLES THAT, ACCORDING TO WARRANTY RECORDS, HAVE HAD A SUSPECT REPLACEMENT CLOCKSPRING INSTALLED, WILL ALSO BE INCLUDED IN THIS CAMPAIGN. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT DAIMLERCHRYSLER AT 1-800-853-1403.
The contact owns a 1998 Dodge Ram 2500 equipped with Mastercraft Tires, Tire Line: Courser AXT, Tire Size:245/75/R16, DOT Number: [XXX] . The contact stated that while driving 65 MPH, the vehicle started shaking abnormally. The contact stated that the abnormal shaking worsened, and the contact pulled over and discovered a bulge in the rear driver’s side tire. The contact replaced the tire with the spare and resumed normal driving. Upon returning to the residence, while inspecting the front passenger’s side tire, the contact cut his index and middle finger on the left hand due to the steel belt protruding from the tire. Upon further inspection, the contact discovered the same failure with the rear driver’s side tire that was replaced. The contact had not sought medical attention for the injuries. The contact attempted to call the manufacturer for assistance but was unable to reach a representative. The tires were not replaced. The tire failure mileage was approximately 3,000. The vehicle failure mileage was approximately 305,000. The VIN was not available. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)
The dash has completely desegregated exposing all the wires, air conditioning unit, and airbag parts. This is a huge hazard because my headlight switch hangs with nothing to attach to. My airbags are completely visible and could explode at anytime. Everything that was in the dash heated seat, headlight, air system, radio, speedometer, and airbag controls are completely visible and all attachments are completely desegregated I do not know if this also caused the loose steering in my vehicle but I assume it did the steering wheel will turn about a quarter turn before it ever engages the wheels and when driving you must constantly move the wheel back and forth to keep the car in the road I feel as though this is a major issue that has not been recalled in the dodge rams all models of my year truck that has been reported several times and should be fixed there are plenty of these trucks on the road still and all have the same issues I cannot afford another vehicle and would like for mine to be recalled and fixed so I can drive it safely without worrying about the airbags deploying or the steering being so lose it causes me to have a accident. When the plastic degenerates it also leaves extremely sharp edges that will cut you extremely deep I have been cut several times getting things from the dash pad I have lid across it covering the gapping hole. thank you for your time and consideration . Side note I tried to upload pictures of the dash or what's left of it but it would not let me.
The 2000 Dodge RAM 2500 has 2 NHTSA recalls and 219 consumer complaints on file. The high number of complaints suggests potential reliability concerns — review the complaint details above before purchasing. For the most detailed information about a specific vehicle, decode its VIN using our free decoder above.
Enter a specific VIN to get the full report — specs, recalls, safety ratings, complaints, investigations, and technical service bulletins.
In Muskogee County.By the grace of God, I finally gain control of my vehicle, after applying the brakes that failed on me, to avoid an accident, I pulled over to inspect my vehicle. I did a walk around inspection and noticed left rear side a puddle of oil on the ground, a oil leaks right next to the fuel tank inside the frame. After getting into my vehicle I noticed, my ABS light come on. So, I had it tow home. Prior to this I did not have an inspection to see it was safe to drive and I did not report this to the police.
They Did Not INCLUDE THE 2000 Dodge Ram 2500 Yet I have had the same experience several times.When travelling at highway speeds and hitting a bump or pot-hole in the road, the front end begins to shake violently and does not stop until the driver jams on the brakes and brings the truck back down to below highway speeds. Some people contribute this phenomenon to the worst possible downside of having a coil-sprung front suspension on a truck with a track bar. Unlike a typical suspension set up, Dodge Ram trucks will continue to shake long after hitting the bump to the point that controlling the vehicle is nearly impossible until the driver slows down. The current lawsuit alleges that Chrysler learned about the death wobble defect with Dodge Ram trucks in the mid-2000s but waited four years before conducting a series of recalls from 2009 through 2013. Chrysler classified the recalls as Safety Recalls, H36, H46, K28, L16, N62, N49, and N63. The recalls addressed various parts of 2009-2012 Dodge Ram trucks’ steering linkage system, including its tie rod assemblies. The complaint alleges that the recalls excluded many affected vehicles and that Chrysler provided replacement parts that were also defective, forcing Chrysler to make additional recalls to remedy prior recalls. Consumers have reported that Chrysler does not have enough replacement parts to repair all the vehicles for which it has submitted recall notices and that drivers have been put on long waiting lists for repairs. Chrysler’s steering linkage defect and redesign. Allegedly, the ball stud is defective in the Chrysler Suspension design. The driver’s side tie-rod ball stud that Chrysler used is too weak to and is known to fracture under normal driving conditions. The tie rod is a “crucial link” in the vehicle’s steering system. A loose tie rod can cause any vehicle to have an excess shimmy or the dreaded death wobble. The tie rod can affect front-end alignment. This happen several times in the last 15 years
DASH CRACKED AND SHATTERED TO PIECES, WITH NO REASON APPARENT REASON AND/OR WITHOUT OPERATOR'S CONTROL. PART OF IT HAPPENED WHEN I WAS DRIVING.
VAN FRAME IS RUSTING OUT, STEERING BOX THAT IS MOUNTED TO FRAME IS LIKELY TO FALL OFF SOON. TIE ROD TO FRAME CONNECTION ALSO IS RUSTING OUT. TO MY KNOWLEDGE AND AFTER RESEARCH ON THE INTERNET, THERE IS NO REASONABLE FIX.
TL* THE CONTACT OWNS A 2000 DODGE RAM 2500. THE CONTACT STATED THAT THE DASHBOARD WAS FRACTURED. THE DASHBOARD WAS PREVIOUSLY REPLACED TWICE FOR THE SAME FAILURE. THE CONTACT WAS AFRAID THAT THE AIR BAGS WOULD DEPLOY WITHOUT WARNING. THE DEALER WAS NOT NOTIFIED OF THE FAILURE AND NO REPAIRS WERE MADE. THE FAILURE MILEAGE WAS 90,000.
THE DASHBOARD AROUND THE INSTRUMENT CLUSTER, RADIO, AND HEAT/AC CONTROLS IS BREAKING INTO PIECES. I AM CONCERNED THAT THIS WILL BE A SAFETY ISSUE IN THE EVENT OF AN ACCIDENT. THIS IS BECAUSE OF THE SHARP AND JAGGED EDGES AND LOOSE MATERIAL ALL THROUGHOUT THE DASH AREA. CURRENTLY I HAVE ZIP TIES HOLDING MY HEAT/AC CONTROLS IN PLACE AND 2 REMAINING FACTORY SCREWS HOLDING MY RADIO IN PLACE. THE TOP PORTION OF THE DASH ALSO HAS FAILED AND FALLEN APART OVER THE YEARS AND DUE TO SAFETY CONCERNS, I HAVE ALREADY REPLACED IT. I HAVE BEEN UNSUCCESSFUL IN FINDING A SUITABLE REPLACEMENT LOWER DASH ASSEMBLY TO REPLACE MINE WITH.
THE METAL SURROUNDING THE DOOR LATCH HAS RIPPED IN HALF LEAVING A GAPING SEAM AND THE DOOR LATCH WILL NOT KEEP THE DRIVER'S SIDE DOOR SAFELY CLOSED. THEREFOR, BECAUSE THIS IS A DAILY DRIVER FOR ME, I HAVE TO USE A 1,000 LB CARGO STRAP TO KEEP THE DOOR SHUT UNTIL I CAN FIND A WAY TO GET IT FIXED.
TL* THE CONTACT OWNS A 2000 DODGE RAM 2500. DURING AN OIL CHANGE, THE MECHANIC STATED THAT THE BRACKET THAT HELD THE CONTROL ARM TO THE FRONT AXLE CORRODED. THE VEHICLE WAS NOT REPAIRED. THE MANUFACTURER NOT NOTIFIED OF THE FAILURE. THE APPROXIMATE FAILURE MILEAGE WAS 119,000.
DASH BOARD HAS DESINTEGRATED DUE TO FAULTY MATERIALS. DASH HAS BEEN COVERED SINCE ABOUT 2 WEEKS AFTER DATE OF PURCHASE WHICH WAS DEC 31ST 1999. TRUCK WAS ORDERED STRAIGHT FROM THE FACTORY AN I AM THE ONLY OWNER OF THE VEHICLE SINCE DAY 1. SET PAPERS ON DASH AND WHEN I PICKED THEM UP REALISED A SOFT SPOT IN THE DASH MAT. LIFTED MAT TO FIND LARGE HOLE IN DASH.
COMPLETELY CRACKED DASH BOARD TOP IN TWO PLACES
PLASTIC DASHBOARD HAS MULTIPLE FRACTURES AND CRACKS THROUGH NO FAULT OF MINE. MANY OF THE EDGES ARE VERY SHARP AND COULD LEAD TO SERIOUS INJURY IF THE VEHICLE WAS INVOLVED IN AN ACCIDENT AND ONE OF THE OCCUPANTS WAS THROWN INTO , OR CONTACTED THE DASH WITH ANY PART OF THEIR BODY. THIS IS RIDICULOUS THAT THE DASHBOARD IS FALLING APART ON THIS PICKUP ALL BY ITSELF. I SUSPECT AT SOME POINT I WON'T BE ABLE TO DRIVE THE VEHICLE ANYMORE BECAUSE THE GAUGES WILL BE LAYING ON THE FLOOR.
TL* THE CONTACT OWNS A 2000 DODGE RAM 2500. THE CONTACT RECEIVED NOTIFICATION OF NHTSA CAMPAIGN NUMBER: 15V313000 (AIR BAGS) HOWEVER, THE PART TO DO THE REPAIR WAS UNAVAILABLE. THE CONTACT STATED THAT THE MANUFACTURER EXCEEDED A REASONABLE AMOUNT OF TIME FOR THE RECALL REPAIR. THE MANUFACTURER WAS MADE AWARE OF THE ISSUE. THE CONTACT HAD NOT EXPERIENCED A FAILURE.
TL* THE CONTACT OWNS A 2000 DODGE RAM 2500. WHILE DRIVING APPROXIMATELY 30 MPH, THE ENGINE STALLED WITHOUT WARNING. THE CONTACT WAS ABLE MANEUVER THE VEHICLE INTO A PARKING LOT. THE CONTACT WAS UNABLE TO RESTART THE VEHICLE. THE VEHICLE WAS TOWED. THE VEHICLE WAS NOT DIAGNOSED OR REPAIRED. THE MANUFACTURER WAS NOT MADE AWARE OF THE FAILURE. THE APPROXIMATE FAILURE MILEAGE WAS 68,000.
Showing 15 of 219 complaints