1990 Nissan 240Sx

Component: SEAT BELTS:FRONT:BUCKLE ASSEMBLY

THE FRONT SAFETY BELT BUCKLE RELEASE BUTTONS CAN BREAK. THESE RED PLASTIC RELEASE BUTTONS ARE MARKED "PRESS." IF A BUTTON BREAKS, PIECES CAN FALL INTO THE BUCKLE ASSEMBLY CAUSING THE BUCKLE TO OPERATE IMPROPERLY.

Consequence: THE SAFETY BELTS WOULD NOT PROVIDE ADEQUATE PROTECTION TO AN OCCUPANT IN A VEHICLE CRASH.

Remedy: OWNERS SHOULD PROMPTLY CHECK THE CONDITION AND OPERATION OF BOTH FRONT SAFETY BELT BUCKLES AND CAREFULLY INSPECT THE RED RELEASE BUTTON FOR ANY BREAKS OR CRACKS. THEY SHOULD ENSURE THAT BOTH BUCKLES ARE OPERATING PROPERLY BY INSERTING EACH LATCH PLATE INTO ITS BUCKLE, TUGGING ON THE BELT TO MAKE SURE THE LATCH IS SECURELY LOCKED, AND THEN PRESSING THE RELEASE BUTTON. THE LATCH PLATE SHOULD POP OUT OF THE BUCKLE WHEN THE BUTTON IS PRESSED. IF EITHER RELEASE BUTTON SHOWS A SIGN OF BREAKING OR CRACKING OR IF EITHER BUCKLE FAILS TO OPERATE PROPERLY, OWNERS SHOULD PROMPTLY CONTACT THEIR AUTHORIZED DEALER TO SCHEDULE AN APPOINTMENT TO HAVE THE BUCKLE REPLACED OR REPAIRED FREE OF CHARGE.

Full recall detail →

TL* THE CONTACT OWNS A 1990 NISSAN 240SX. THE CONTACT RECEIVED A RECALL NOTIFICATION FOR NHTSA CAMPAIGN NUMBER: 95V103002 (SEAT BELTS). THE CONTACT WAS EXPERIENCING A FAILURE; HOWEVER, THE DEALER WOULD NOT HONOR THE RECALL AND WANTED TO CHARGE THE CONTACT FOR THE REPAIR. THE MANUFACTURER WAS NOTIFIED OF THE FAILURE. THE FAILURE MILEAGE WAS UNKNOWN.

THE FACTORY BREAK BOOSTERS ON NISSAN 240SX MODEL YEARS 1989-1998 LEAK AND DRIP BREAK FLUID ONTO THE FRAME RAIL, EATING AWAY THE RUST PREVENTIVE COATING. THIS ALLOWS THE ELEMENTS TO CONTACT BARE METAL, OXIDIZING IT AND BOTH WEAKENING THE STRUCTURE OF THE VEHICLE AND POTENTIALLY CAUSING THE BREAKS TO FAIL.

I HAVE PURCHASED THIS AUTO APRIL 20, 2005. I DROVE IT FOR APPROXIMATELY TWO WEEKS. THEN AN OVERPOWERING ODOR OF GASOLINE EMITTED IN THE PASSENGER COMPARTMENT. UPON INSPECTION OF THE ENGINE COMPARTMENT, THERE WAS GASOLINE LEAKING FROM THE FUEL RAIL. I HAVE HAD THE O-RINGS AND INSULATORS REPLACED ON ALL FOUR FUEL INJECTORS AND THE LEAK IS STILL PRESENT. IT SEEMS THAT I MUST NOW REPLACE THE INJECTORS. IN CHECKING FOR POSSIBLE RECALLS, I HAVE NOTICED THERE WERE SEVERAL OTHER COMPLAINTS MADE REFERRING TO THE FUEL SYSTEM ON THESE MODELS, AND THAT NISSAN WOULD NOT RECALL THE 240 SX EVEN THOUGH THE EXACT SAME DESIGN IS USED IN THE FOUR CYLINDER ENGINE AS THE SIX CYLINDER MODELS THAT THEY DID RECALL. !!! WHY NOT THE 240 SX, NISSAN????? I INTEND TO KEEP ALL OLD PARTS THAT ARE REPLACED.