2019 Toyota Tacoma

Component: SERVICE BRAKES, HYDRAULIC:FOUNDATION COMPONENTS:MASTER CYLINDER

Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain 2018-2019 Toyota Tacoma vehicles. Improper machining of the brake master cylinder may result in internal damage of one of the seals, affecting brake performance.

Consequence: Reduced brake performance can lengthen the distance needed to stop the vehicle, increasing the risk of a crash.

Remedy: Toyota will notify owners, and dealers will replace the brake master cylinder, free of charge. The recall began January 28, 2019. Owners may contact Toyota customer service at 1-888-270-9371. Toyota's numbers for this recall are J16/J06.

Component: EQUIPMENT:OTHER:LABELS

Gulf States Toyota (GST) is recalling certain 2019 C-HR, 4Runner, Avalon, Avalon Hybrid, Camry, Camry Hybrid, Highlander, Land Cruiser, Prius, RAV4, Sequoia, Tacoma, Sienna, Tundra and Yaris vehicles. The text on the load capacity label may become illegible. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) number 110, "Tire Selection and Rims."

Consequence: If the driver cannot read the label, they may unknowingly overload the vehicle, increasing the risk of a crash.

Remedy: GST will notify owners, and dealers will provide corrected load carrying capacity modification labels, free of charge. The recall began May 24, 2019. Owners may contact GST customer service at 1-800-444-1074. GST's number for this recall is 19R1.

While driving at Highway speeds fuel pump failed resulting in near miss collision on Interstate. Initial fuel pump was replaced with recall. This is second pump that failed. Vehicle towed to Bob Tyler Toyota in Pensacola Fl where fuel pump replaced by owner. Toyota refuses to pay for pump even though class action lawsuit resulted in Toyota being responsible for reimbursement. Vehicle has only 36000 miles.

On 10/9/25 said vehicle was brought to Central Florida Toyota (CFT) for the investigation of water intrusion into the rear passenger compartment. The cause of water intrusion was due to a defective duct (vent) assy (PN: 62930-04040. There are 2 vents located at the rear of the passenger cab.). The cost for the repair was estimated to be $15,153.39. This exorbitant fee includes the replacement of the entire carpeting system and the need to remove the vehicle bed to access the vents. Based on a musty smell CFT assumed that the carpet had been damaged by molds. Subsequently, CFT was requested to have the 2 vents replaced, only, and not the carpeting. In return, CFT stipulated that I must sign a health hazard waiver due the assumed (no evidence) moldy condition. Now, not only can 2 simple mechanical vents cause such an exorbitant fee to repair it has now evolved into a potential health safety issue. Yet, Toyota has failed to provide any caution/warning to the effect of water intrusion into the rear of the passenger area. No caution/warning in owner's manual that vehicle owner must periodically inspect the rear passenger for water, no warning tags/labels inside vehicle. On the other, my Toyota OEM floor mats have all sorts caution/warning plus installation instruction. It is recommended, as a minimum, Toyota must issue a recall to confirm the integrity of all vents in circulation. On my vehicle, the defective vent was due to bad seal which implies poor manufacturing. Secondly, the location of the vents is simply poor engineering. Even, if there's no damage to the carpeting the cost to replace the 2 vents would be $2,500 due to the need to vehicle bed removed.

Water leaked through the third brake light assembly into the cab roof, soaking the ceiling, seats, and carpet. This caused extensive mold growth and electrical corrosion near the control modules. The affected systems include the third brake light seal, cab roof, interior materials, and ECM (documentation attached). The truck remains at the dealer and is available for inspection upon request. The entire interior is contaminated with mold, creating a serious health hazard, and the vehicle cannot be safely driven or occupied. The leak also damaged electrical components, posing a risk of malfunction or short-circuit while operating the vehicle, and it is currently undrivable due to this damage. The problem was confirmed by Toyota of Clermont, which inspected the truck, documented the damage, and provided a written estimate exceeding $8,000 for repairs (copy attached). The vehicle was at the dealership while the manufacturer’s Limited Service Campaign 21TD03—issued to address this same defect—was still active, but the required inspection and seal repair were not performed. The failure of Toyota of Clermont to perform the mandated remedy under Campaign 21TD03 while the vehicle was in its possession resulted in a serious safety hazard. The entire interior of the cab—including the seats, ceiling, and carpet—is covered in mold, and the vehicle is undrivable due to water intrusion and electrical damage. There were no warning lamps or error messages before the failure, only a strong musty smell inside the cab shortly before the leak became visible. Toyota Motor North America was notified but declined responsibility. This case represents a potential noncompliance with federal defect-remedy obligations under the National Traffic and Motor Vehicle Safety Act (49 U.S.C. § 30120) and should be investigated as such.

The rear cabin pressure vent leaks water into the cabin creating an unsafe vehicle to drive during rainy days. I took the vehicle to Sarasota Toyota and was told that my claim to get it fixed thru the Toyota warranty was denied because it is considered trim. I contacted the warranty company and Toyota about this issue but was told the same.NOT COVERED. I am also concerned that the water intrusion can affect the safety and health hazard of more drivers with this problem if not addressed by Toyota as soon as possible.

While having routine maintenance performed on 8/5/2025, I was advised that the steering rack must be replaced at an approximate cost of $2,200. I was told this should be done as soon as possible because it poses a safety issue. The vehicle only has 29,000 miles and has not been driven off road or in extreme conditions. I researched the issue and it seems that a number of complaints have been filed for the same concern, specifically because this is happening at such low mileage. If Toyota does not come up with a resolution and recall for faulty equipment, will I be doing this repair again in another 29,000 miles?

The contact owns a 2019 Toyota Tacoma. The contact stated that the rear cabin pressure vent seals had deteriorated, causing rainwater to leak into the rear cabin of the vehicle. The contact stated that there was a mildew odor inside the cabin of the vehicle. The contact was concerned that mold had developed inside the vehicle due to the water inside the vehicle. The vehicle was taken to the local dealer, who indicated that the rear pressure seals were faulty and needed to be replaced. The vehicle was not repaired. The manufacturer was notified of the failure, but no assistance was provided. The failure mileage was 80,000.

Rear leaf springs are flat and curving in opposite direction causing vehicle to bottom out with only 100 pounds in the truck bed. This is a potential safety issue as control problems to keep vehicle going straight.

Truck has 33,XXX miles. Was driving and the fuel gauge needle dropped to E. Dash screen stated 225 miles till empty please refuel. I tried turning it on and off, no change. Filled the gas tank numerous times, no change. Needle remains on E with warning message to please refuel. Mechanic checked and there are no codes or CELs.

I’m filing this complaint regarding a known issue with the A/C evaporator core on my Toyota Tacoma (3rd generation). The evaporator core has prematurely failed, leading to a complete loss of air conditioning and, more importantly, reduced defrosting and defogging capabilities that directly affect visibility and driver safety. This issue is widespread and well-documented among Tacoma owners, and Toyota has issued TSB T-SB-0145-20, acknowledging that corrosion in the evaporator core leads to refrigerant leakage. Despite the known defect, Toyota has not issued a recall and is charging owners thousands of dollars to repair a part that is failing far earlier than expected. In my case, the system began blowing only warm air, and the defroster can no longer clear moisture from the windshield, which is a serious safety issue in humid or cold conditions. This should be treated as a systemic defect, not regular wear and tear. Toyota needs to be held accountable for this manufacturing flaw, which affects safety-critical components like the defroster and visibility systems.

My check engine light came on when I was traveling in Oregon. I didn't notice any major changes in my vehicle's performance. Drove it all the way back to Colorado without issues. It went off and came back on several times. I replaced the cabin air filter, engine air filter and put fuel injector cleaner in the vehicle. Finally I took it in to the Toyota dealership to get an oil change and then the check engine light came back on. I paid for them to do a diagnostic test and they stated they were almost certain it was the 2nd fuel injector running rich. Brought it back a week later for the repair. Fyi...I was still getting 20 mpg in fuel and I wasn't noticing anything major in performance. They replaced the fuel injector and then the check engine light came back on with a different code. They are now running "another" more expensive diagnostic test and I still don't have my truck. They are saying it could be the 2nd cylinder or the engine and claiming it has 150,000 miles so I should expect these issues (and conveniently my warranty has run out).

I have the exact same issues as the big recall done with the Toyotas for the brake master cylinder. My Tacoma is leaking brake fluid from the inside of the cabin! I contacted Toyota showed the pictures and evidence, I have the exact same issue as all the other trucks with the recall, Toyota refused to help me fix my truck, even tho everything is exactly the same. They argued that because the date my truck was assembled is why they wouldn’t help. They cannot track which parts are used for which dates! It’s not fair, they know this is a huge problem which is why they had a large recall for the Tacomas. My truck barely had 55k miles on it, I shouldn’t be having brake master cylinder issues at this mileage, it’s a 2019, it’s way too new for these problems! This should be covered under the recall. It’s a faulty seal from the inside of the brake master cylinder. Toyota refuses to help or fix it. This is a severe safety issue and concern, I could have crashed or killed myself. My warranty just expired in December. This master cylinder is only made by Toyota and it’s a $1600 part. This should all be covered by Toyota under the recall for safety! This is now going to cost me around $2,000 to fix out of my pocket, all for my own safety. My truck sat for 2-3 weeks waiting for Toyota all for them to deny helping me.

Engine Block