2008 Ford Fusion

Component: SERVICE BRAKES, HYDRAULIC:ANTILOCK/TRACTION CONTROL/ELECTRONIC LIMITED SLIP:CONTROL UNIT/MODULE

Ford Motor Company (Ford) is recalling certain 2006-2010 Ford Fusion, Mercury Milan, Lincoln Zephyr and MKZ vehicles. The valves within the ABS Hydraulic Control Units (HCU) may react with brake fluids containing specific corrosion preventative additives. This reaction may cause the valves to not close properly.

Consequence: If the valves do not properly close, additional brake pedal travel may be required to stop the vehicle, increasing the risk of a crash.

Remedy: Ford will notify owners, and dealers will flush the brake system with DOT 4 fluid and install a new brake fluid reservoir cap. In addition, the HCU will be tested to detect a possible stuck valve condition, replacing the HCU as necessary. All services will be performed free of charge. The recall began April 1, 2021. Owners may contact Ford customer service at 1-866-436-7332. Ford's number for this recall is 19S54.

Full recall detail →

Component: AIR BAGS:FRONTAL:PASSENGER SIDE:INFLATOR MODULE

Ford Motor Company (Ford) is recalling certain 2012 Ford Fusion and Mustang and Lincoln Zephyr and MKZ vehicles originally sold, or ever registered, in Alabama, California, Florida, Georgia, Hawaii, Louisiana, Mississippi, South Carolina, Texas, Puerto Rico, American Samoa, Guam, the Northern Mariana Islands (Saipan), and the U.S. Virgin Islands, or "Zone A." Additionally, unless included in "Zone A" above, Ford is recalling certain 2009 Ford Ranger, Edge, Fusion and Mustang, Lincoln MKX, MKZ and Zephyr and Mercury Milan vehicles originally sold, or ever registered, in Arizona, Arkansas, Delaware, District of Columbia, Illinois, Indiana, Kansas, Kentucky, Maryland, Missouri, Nebraska, Nevada, New Jersey, New Mexico, North Carolina, Ohio, Oklahoma, Pennsylvania, Tennessee, Virginia and West Virginia, or "Zone B." Additionally, unless included in "Zone A" or "Zone B" above, Ford is recalling certain 2007-2008 Ford Ranger, Edge and Lincoln MKX, 2006-2008 Ford Fusion, Mercury Milan, Lincoln Zephyr and MKZ, 2005-2008 Ford Mustang and 2005-2006 Ford GT vehicles originally sold, or ever registered, in the states of Alaska, Colorado, Connecticut, Idaho, Iowa, Maine, Massachusetts, Michigan, Minnesota, Montana, New Hampshire, New York, North Dakota, Oregon, Rhode Island, South Dakota, Utah, Vermont, Washington, Wisconsin and Wyoming. These vehicles are equipped with certain air bag inflators assembled as part of the passenger frontal air bag modules used as original equipment or replacement equipment. In the event of a crash necessitating deployment of the passenger frontal air bag, these inflators may rupture due to propellant degradation occurring after long-term exposure to absolute humidity and temperature cycling.

Consequence: An inflator rupture may result in metal fragments striking the vehicle occupants resulting in serious injury or death.

Remedy: Owners are advised not to drive their vehicles until the repair has been performed. Ford will notify owners, and dealers will replace the passenger frontal air bag inflator, free of charge. Interim letters informing owners of the recall and that parts are not yet available began mailing March 1, 2017. Owners will receive a second notice when remedy parts become available. Owners may contact Ford customer service at 1-866-436-7332. Ford's number for this recall is 19S01.

Full recall detail →

Component: AIR BAGS:FRONTAL:PASSENGER SIDE:INFLATOR MODULE

Ford Motor Company (Ford) is recalling certain model year 2007-2011 Ford Ranger vehicles, 2006-2011 Ford Fusion, Mercury Milan and Lincoln Zephyr/MKZ vehicles, 2007-2010 Ford Edge, Lincoln MKX vehicles, 2005-2006 Ford GT vehicles, and 2005-2011 Ford Mustang vehicles originally sold, or ever registered, in Alabama, California, Florida, Georgia, Hawaii, Louisiana, Mississippi, South Carolina, Texas, Puerto Rico, American Samoa, Guam, the Northern Mariana Islands (Saipan), and the U.S. Virgin Islands, or "Zone A." Additionally, unless included in "Zone A" above, Ford is recalling certain model year 2007-2008 Ford Ranger, Edge and Lincoln MKX vehicles, 2006-2008 Ford Fusion, Mercury Milan and Lincoln Zephyr/MKZ vehicles, 2005-2006 Ford GT vehicles and 2005-2008 Ford Mustang vehicles originally sold, or ever registered, in Arizona, Arkansas, Delaware, District of Columbia, Illinois, Indiana, Kansas, Kentucky, Maryland, Missouri, Nebraska, Nevada, New Jersey, New Mexico, North Carolina, Ohio, Oklahoma, Pennsylvania, Tennessee, Virginia, and West Virginia, or "Zone B." Any vehicle not included in "Zone A", or "Zone B" is not included in the safety recall. These vehicles are equipped with certain air bag inflators assembled as part of the passenger frontal air bag modules, and used as original equipment or replacement equipment. In the event of a crash necessitating deployment of the front air bags, these inflators may rupture due to propellant degradation occurring after long-term exposure to absolute humidity and temperature cycling.

Consequence: An inflator rupture may result in metal fragments striking the vehicle occupants resulting in serious injury or death.

Remedy: Owners are advised not to drive their vehicles until the repair has been performed. Ford will notify owners, and dealers will replace the passenger frontal air bag inflator, free of charge. Ford mailed interim letters informing owners that parts are not yet available on July 15, 2016. Owners will receive a second notice when remedy parts become available. Owners may contact Ford customer service at 1-866-436-7332. Ford's number for this recall is 19S01.

Full recall detail →

Component: EQUIPMENT

Ford Motor Company (Ford) is recalling certain all weather driver side accessory floor mats sold for use in model year 2006-2011 Ford Fusion and Mercury Milan, 2006 Lincoln Zephyr, and 2007-2011 Lincoln MKZ vehicles manufactured November 9, 2007, through October 31, 2010. The affected floor mats may move and possibly interfere with the accelerator pedal.

Consequence: The floor mat could shift such that it could interfere with the accelerator pedal, preventing its return to an idle position, which could result in unintended vehicle speeds, increasing the risk of a crash.

Remedy: Ford will notify owners, and dealers will install new replacement mats, free of charge. The recall began in July 2014. Owners may contact Ford's customer service at 1-800-392-3673. Ford's number for this recall is 14S07. NOTE: Vehicles built after October 31, 2010, while potentially equipped with the same floor mats, are equipped with a Brake Over Accelerator (BOA) feature that prevents simultaneous accelerator and brake application, allowing the vehicle to be safely stopped by pressing firmly and steadily on the brake pedal.

Full recall detail →

Door handle is stuck/broken. Door cannot open from the inside or outside. Passengers are stuck in car.

The vehicle brakes will engage at random intervals without the brake pedal being touched. This happens at all speeds, and even at a stop. Issue still occurs daily, and has been ongoing for 5+ years. Brake master cylinder and aux boost pump have been replaced twice with OEM parts, and three complete brake jobs (pads, calipers and rotors) in the last 5 years. At slower speeds, it manifests as a drag to forward motion. At higher speeds, the drag is more pronounced, and causes the car to decelerate. It has also caused the tires to "hop" during travel, causing loss of vehicle control. Luckily, no accidents so far. I am aware of the recall for the HCU (ABS Module) for this vehicle, but four different Ford dealerships have declined to examine closer, citing recall 19S54 as a "customer experience" issue, not a safety issue. The brake fluid replacement (DOT3 to DOT4) has been done, but dealer declined to examine or replace the HCU, citing "out of warranty".

This isn't an incident. I just want to report that Ford Motors will not replace the Hydraulic Control unit that is under recall for my 2008 Ford Fusion. They will only replace cars that are 15 or less years old. My car has 117,000 miles on it. Far less than the yearly average of 14,000 miles. If this truly a safety issue, then I feel that my car should be serviced under the recall. I chatted with the Ford Customer service rep and he informed me that it was safe to drive, But he did tell me to take it to a Ford dealer (of course) and that I would be financially responsible for the repair. So I own a vehicle that is under a recall, but since it's 1 year past the 15 year ownership date, Ford will not repair it under the recall. Thus any Ford owner that owns a vehicle that is older than mine is also out of luck Thank you for taking the time to read this and maybe encourage Ford to do the right thing. My car should not be any less safe than a 2010 car

I want to file a safety complaint against Ford car company for their vehicle in which I purchased which is a 2008 Ford Fusion SEL for excessive and dangerous rot and rust problem on the frame and suspension and under component which can lead to accidents if one of these components fall apart . I purchased a 2008 Ford fusion SEL in Connecticut which used to be a Massachusetts state government vehicle before I've obtained it. It was well maintenance and had no flood damage. But just like a wide range of cars from Ford especially this model that I've purchased has a serious problem with excessive rust which make the car very dangerous to drive. Mind's speaking I've had to have framework done to my vehicle and change multiple suspension parts because of all the rust my transmission pan literally fell apart and all the oil came because it was so rusted. My stabilizer links and control arms have fell apart in which obstructs the steering which also caused a safety hazard for me and other people on the road. Ford has a duty to design their cars with a certain level of weather resistance. After doing research I found that there is a wide range of customers who's having the same having the same problems with this year make and model just like other vehicles that are made by ford. All the problems that stated in this complaint having verified by ASE certified mechanics that I've been working on my vehicle. The contact stated all the original metal components like control arms, tie rods, suspension shocks and struts and frame all have a issue with rot rust and corrosion which led to vehicles having alignment issues.

The contact owns a 2008 Ford Fusion. The contact stated that while his girlfriend was driving at undisclosed speeds, the vehicle hydroplaned, and the anti-lock brakes engaged and disengaged. The brake pedal became inoperable. The vehicle was taken to the local dealer, where it was determined that the vehicle had passed testing. The vehicle was repaired, but the failure recurred. While driving the vehicle, the brake pedal was squishy and would depress to the floorboard. The contact stated that the solenoid was stuck open. There were no warning lights illuminated. The manufacturer was contacted, but no assistance was provided. The contact stated that the failure was related to NHTSA Campaign Number: 19V904000 (Service Brakes, Hydraulic). The failure mileage was approximately 79,259.

The dashboard has warped. The seems on the dashboard around the passenger side airbag cover have become partially unattached to the rest of the dashboard and have caused an opening above passenger side airbag that may allow for debris/dirt to enter into safety equipment and could potentially lead to serious hazards to person if airbag unit deploys. The plastic vent and sensor under the windshield located in the very top front of the dashboard has cracked and has also become dislodged and lifteb from dashboard housing and can pose safety issues if in a collision. There is also some notable brittleness arising in the dashboard material. The warping of the dashboard and its components pose strong safety concerns and a risk to service departments doing recall repairs for manufacturers. There are many similar vehicles produced by this manufacturer during this time that have had same dashboard failures and at the very least it was been the root of stress anxiety for owners and repair dealerships.

The contact owns a 2008 Ford Fusion. The contact stated that while driving approximately 55 MPH, the check engine warning light illuminated. The message that the engine was overheated was displayed. The vehicle was towed to the local dealer, where it was diagnosed that coolant had leaked into the compression chamber and the engine needed to be replaced. The vehicle was not repaired. The manufacturer was notified of the failure. The failure mileage was approximately 68,000. The VIN was not available.

I just bought this car and the brakes do not feel right when i go to stop. They are new and i got them changed today and it still makes a pop noise.

I discovered my drivers rear brake light bulb melted in their socket. The socket themselves are burnt black and the drivers side tail light case has been hot enough to melt. A quick search on the Internet turns up a lot more chatter about this same issue. Even scarier is the fact that this happening with zero warning. No blown fuse, no codes, nothing to indicate your frying stuff in the back at all. The dealership denies hearing anything , Ford denies hearing anything, even though it's happening all over the country and I found at least five other complaints listed with the National Highway Traffic Safety Administratiion. I took car in for oil change and discovered this but want $250 for repair and no guarantee it won't happen again. I'm a senior with limited income and it's a 2008 Ford fusion SE HELP NEED RECALL!

The contact owns a 2008 Ford Fusion. The contact stated that there was a squealing sound coming from underneath the dashboard. The vehicle was hard shifting while accelerating or while idling. The check engine warning light was illuminated. The vehicle was taken to the dealer who was unable to identify the cause of the failure. The vehicle had not been repaired. The failure persisted and the vehicle was taken to the dealer approximately 8-times. The manufacturer was made aware of the failure and confirmed that the vehicle was not included in TSB Number: 10052190 (Power Train). The approximate failure mileage was 143,300. The repairs were made at the owner's expense in the amount of $2196.46.

Driving around 55 and put brakes on and went 3/4 to floor like they were out. 2 other people experienced the same. HCA Unit must be bad or corrosive. I read online about this. Ford has extended warranty recall and sent letter and fluid changed 14 yes later. We'll that's a little late cause obviously unit bad now. Ford dealer will not replace cause can't duplicate problem. If I wreck, Ford is liable for 4 to 5 people in car. Common sense would be REPLACE PART!!!