Loading vehicle data from NHTSA...
NHTSA recalls, safety ratings, and consumer complaints for the 1981 Ford F600.
NHTSA has not published 5-star crash-test ratings for the 1981 Ford F600. New vehicles are often added to the NCAP rating program after initial release; check nhtsa.gov/ratings for the latest status.
Component: SERVICE BRAKES, HYDRAULIC:FOUNDATION COMPONENTS:HOSES, LINES/PIPING, AND FITTINGS
THE BRAKE MASTER CYLINDER TO CHASSIS TUBE AND HOSE ASSEMBLY MAY HAVE BEEN LOCATED IN SUCH A WAY THAT IT IS SUSCEPTIBLE TO CHAFING DURING VEHICLE OPERATION. CONTINUED CHAFING MAY RESULT IN TUBE OR HOSE FAILURE AND SUBSEQUENT LOSS OF BRAKE FLUID.
Remedy: THE DEALER WILL INSPECT AND, IF NECESSARY, INSTALL A BRAKE LINE ATTACHING CLIP AND REPLACE ANY DAMAGED BRAKE TUBE AND HOSE ASSEMBLY WITHOUT CHARGE.
Component: VEHICLE SPEED CONTROL:CABLES
THESE VEHICLES MAY HAVE BEEN MANUFACTURED WITH AN INCORRECT END CLAMP ON THE HAND THROTTLE ACTUATING CABLE. UNDER CERTAIN CONDITIONS, PERTAINING TO THE CLAMP-TO-THROTTLE CABLE ORIENTATION AND DISTANCES OF THE CABLE TO GOVERNOR SHAFT, THE THROTTLE CABLE END CLAMP MAY INTERFERE WITH THE OUTBOARD ACCELERATOR.
Remedy: THE DEALER WILL INSPECT HAND THROTTLE CLAMP FOR INTERFERENCE AND, IF NECESSARY, REPLACE THESE CLAMPS FREE OF CHARGE.
Component: SERVICE BRAKES, HYDRAULIC:FOUNDATION COMPONENTS:HOSES, LINES/PIPING, AND FITTINGS
THE INVOLVED VEHICLES WERE ASSEMBLED WITH THE LEFT FRONT BRAKE TUBE RETAINING CLIP MISSING. THE ABSENCE OF A RETAINING CLIP MAY ALLOW THE BRAKE TUBE TO RUB AGAINST THE SHOCK ABSORBER, CAUSING WEAR ON THE TUBE AND, EVENTUALLY, LOSS OF BRAKE FLUID.
Remedy: MISSING BRAKE TUBE CLIPS WILL BE INSTALLED AND ANY CHAFED BRAKE TUBES WILL BE REPLACED.
Component: ELECTRICAL SYSTEM:WIRING
THE PRIMARY CIRCUIT CONNECTION, WHICH PROVIDES PRIMARY ELECTRICAL POWER TO THE ENGINE, COULD DETERIORATE DUE TO HIGH CURRENT DRAW PRODUCED BY BUILDER-INSTALLED EQUIPMENT.
Remedy: THE MAIN CAB WIRING HARNESS ELECTRICAL CONNECTOR WILL BE MODIFIED TO ELIMINATE DETERIORATION AT NO CHARGE TO OWNER.
Component: SERVICE BRAKES, HYDRAULIC:FOUNDATION COMPONENTS:HOSES, LINES/PIPING, AND FITTINGS
THE MASTER CYLINDER TO CHASIS BRAKE TUBE AND HOSE ASSEMBLIES MAY HAVE BEEN MOVED FROM THEIR INTENDED POSITION, WHICH COULD ALLOW CHAFING AGAINST UNDERBODY COMPONENTS. CHAFING PROMOTES WEAR OF THE BRAKE TUBE AND HOSE ASSEMBLY AND COULD CAUSE A LOSS OF BRAKE FLUID.
Remedy: UPON INSPECTION BRAKE TUBE CLIPS WILL BE INSTALLED, IF NECESSARY, AND BRAKE TUBES AND HOSE ASSEMBLIES WILL BE REPLACED OR REROUTED.
No consumer complaints filed with NHTSA for the 1981 Ford F600.
The 1981 Ford F600 has 5 NHTSA recalls and 0 consumer complaints on file. For the most detailed information about a specific vehicle, decode its VIN using our free decoder above.
Enter a specific VIN to get the full report — specs, recalls, safety ratings, complaints, investigations, and technical service bulletins.