2006 Cadillac SRX Recalls

Component: ELECTRICAL SYSTEM:IGNITION

This defect can affect the safe operation of the airbag system. Until this recall is performed, customers should remove all items from their key rings, leaving only the ignition key. The key fob (if applicable), should also be removed from the key ring. General Motors LLC (GM) notified the agency on July 2, 2014 that they are recalling 554,328 model year 2003-2014 Cadillac CTS vehicles manufactured August 16, 2001, to April 28, 2014, and 2004-2006 Cadillac SRX vehicles manufactured March 20, 2003, to August 11, 2006. In these models, the weight on the key ring and/or road conditions or some other jarring event may cause the ignition switch to move out of the run position, turning off the engine.

Consequence: If the key is not in the run position, the air bags may not deploy if the vehicle is involved in a crash, increasing the risk of injury.

Full recall detail →

Component: WHEELS:RIM

CERTAIN SPORT UTILITY VEHICLES AND TRUCKS FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 110, "TIRE SELECTION AND RIMS." THESE VEHICLES HAVE AN INCOMPLETE TIRE RIM DESIGNATION ON THE CERTIFICATION/TIRE LABEL LOCATED ON THE DRIVER'S DOOR EDGE. IN ADDITION, THE LABEL MAY ALSO BE MISSING THE TIRE LOAD RATING ON THE LABEL. ALTHOUGH THIS INFORMATION IS NOT REQUIRED BY THE STANDARD, IF A TIRE OF A LESSER LOAD RATING IS INSTALLED, THE TIRE MAY NOT BE ABLE TO SUSTAIN THE LOADS ENCOUNTERED DURING USE.

Consequence: IF A CUSTOMER REPLACES A WHEEL AND ONLY RELIES ON THE RIM SIZE DESIGNATION THAT IS INDICATED ON THE LABEL, A WHEEL THAT IS OF A DIFFERENT RIM CONTOUR DESIGNATION MAY BE INSTALLED. IT MAY BE DIFFICULT OR IMPOSSIBLE TO MOUNT THE TIRE ON A WHEEL WITH THE WRONG CONTOUR. IF THE TIRE IS MOUNTED ON THE WHEEL WITH THE WRONG CONTOUR, THE WHEEL AND TIRE MAY NOT PERFORM AS INTENDED, WHICH COULD INCREASE THE RISK OF A CRASH.

Full recall detail →

Component: POWER TRAIN:AXLE ASSEMBLY:AXLE SHAFT:SEAL

ON CERTAIN PASSENGER VEHICLES, THE REAR AXLE PINION SEAL DOES NOT MEET ALL OF THE SPECIFICATIONS AND MAY EXPERIENCE A FLUID LEAK.

Consequence: A REAR DIFFERENTIAL FAILURE MAY CAUSE LOSS OF MOTIVE POWER AND POSSIBLY LOSS OF CONTROL INCREASING THE RISK OF A CRASH.

Full recall detail →