2019 Toyota Corolla

Component: POWER TRAIN:AUTOMATIC TRANSMISSION:TORQUE CONVERTER

Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain 2019 Toyota Corolla hatchback vehicles equipped with Continuously Variable Transmissions (CVT). The pump impeller blades within the torque converter may detach, especially when driven under high load, potentially causing a vehicle stall.

Consequence: A vehicle stall, especially when driving a high rate of speed, can increase the risk of a crash.

Remedy: Toyota has notified owners, and dealers will replace the CVT and torque converter, free of charge. The recall began April 22, 2019. Owners may contact Toyota customer service at 1-888-270-9371. Toyota's number for this recall is J17/J07.

Component: EQUIPMENT:OTHER:LABELS

Southeast Toyota Distributors, LLC (SET) is recalling certain 2017-2019 Toyota Camry, Corolla, Rav4, Sienna, and Yaris iA vehicles equipped with factory-installed floor mats. The load carrying capacity modification label may be incorrect. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) number 110, "Tire Selection and Rims."

Consequence: An incorrect label may lead to unintentionally overloading the vehicle, increasing the risk of a crash.

Remedy: SET will notify owners and provide a corrected label for placement over the inaccurate label, free of charge. The recall began August 23, 2019. Owners may contact Toyota customer service at 1-888-270-9371. SET's number for this recall is SET19A.

Component: EQUIPMENT:OTHER:LABELS

Gulf States Toyota (GST) is recalling certain 2019 C-HR, 4Runner, Avalon, Avalon Hybrid, Camry, Camry Hybrid, Highlander, Land Cruiser, Prius, RAV4, Sequoia, Tacoma, Sienna, Tundra and Yaris vehicles. The text on the load capacity label may become illegible. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) number 110, "Tire Selection and Rims."

Consequence: If the driver cannot read the label, they may unknowingly overload the vehicle, increasing the risk of a crash.

Remedy: GST will notify owners, and dealers will provide corrected load carrying capacity modification labels, free of charge. The recall began May 24, 2019. Owners may contact GST customer service at 1-800-444-1074. GST's number for this recall is 19R1.

Clutch release bearing/slave cylinder failed at 29,900 miles. Without warning or unusual symptoms, clutch pedal stuck to floor and was unable to shift gears without manually pulling clutch pedal up.

The clutch slave cylinder in my 2019 Toyota Corolla Hatchback failed, causing brake fluid to leak out. The leaking fluid contaminated the clutch assembly, resulting in both the slave cylinder and clutch needing replacement. The failed components should be available for inspection from the repair facility upon request. The failure led to a loss of proper clutch operation, which made it difficult to shift gears and control the vehicle. This created a risk of stalling in traffic or being unable to accelerate when needed, increasing the potential for a collision, especially in busy or high-speed driving conditions. Yes, the issue was diagnosed and confirmed by the dealership. They identified the failed slave cylinder and verified that brake fluid leakage caused contamination of the clutch, requiring replacement of both components. The vehicle has been inspected by a service technician/mechanic at the Toyota dealership. Prior to the failure, there were no warning lights or dashboard messages indicating a problem. The issue appeared suddenly when the clutch began to malfunction due to the fluid leak causing me to not be able to shift gears and the clutch pedal not returning.

Error message that said 'drive start control malfunction. Took 6 mos and numerous attempts to resolve. Replaced numerous parts including the fuel pump because the plastic it's made out of was just disintegrating and and cracking. This has cost thousands of dollars in parts and labor. Also getting a msg on info screen 'connected device not supported' now. Apparently toyota did an update and there was a bug in the program yet I have to pay to fix their error to the dcm.

2019 Toyota Corolla hatchback. Complete transmission failure.

The slave cylinder failed l3aving me stranded in a parking lot. Luckily I wasnt driving down the highway as the slave cylinder is also part of the brake system they use the shared brake fluid reservoir. This is a very common problem and is a 4k plus cost to fix. Not including the time that has to go into fighting the warranty companies and dealers.

The contact owns a 2019 Toyota Corolla. The contact stated that while driving at various speeds, the steering wheel became difficult to turn in either direction. The hazard, power steering, and LDA warning lights were illuminated. The message "Lane Departure Alert Malfunction - Visit your Dealer" was displayed. The contact stated that when the LDA was deactivated, a red power steering warning light was intermittently illuminated. The vehicle was taken to a local dealer, where a battery replacement was performed. The vehicle was repaired; however, the failure reoccurred. The vehicle was taken back to the same local dealer; however, the vehicle was not diagnosed or repaired due to the cost. The vehicle was towed to a local independent mechanic, where it remained for further investigation. The manufacturer was not made aware of the failure. The failure mileage was approximately 1,488.

While the vehicle was parked and powered off, a fire originated inside the driver seat area. There was no collision, no aftermarket electrical equipment installed, and no heated seat or accessory usage at the time of the incident. The vehicle was stationary when the fire began. The fire damage was concentrated within the driver seat assembly, consistent with a suspected electrical failure involving seat wiring, seat-mounted components, or associated harnesses. This is not consistent with owner misuse or external ignition sources. The insurer (Allstate Insurance Company) declared the vehicle a total loss but declined further fire-origin or electrical defect investigation. The vehicle is at risk of being sold or dismantled through a salvage auction, which would destroy critical evidence related to a potential manufacturer defect. The vehicle is currently listed on Copart (Lot# 99091095 highlighted as ‘Run and Drive’) I have completed a Power of Attorney (HSMV 82053) per Allstate requirement, along with a limited conditions notification for evidence preservation however Allstate is refusing to accept the conditions stating their intent to sell it as salvage. This incident presents a serious safety concern involving spontaneous ignition within the passenger compartment. Similar failures pose a risk of injury, death, or property damage, particularly if ignition occurs while occupied. I am requesting that NHTSA review this incident for potential electrical system or seat assembly defects and preserve this complaint as part of any pattern or trend analysis involving Toyota vehicles.

Clutch stopped working while driving. Car has 61,000 miles.

My 2019 hatchback clutch failed Clutch Release Bearing and Slave Cylinder Assembly is leaking. Toyota part # 31400-19027

rattle in transmission. Car hesitates to accelerate randomly leading to unpredictable acceleration sometimes. Transmission is failing.

All 2019-2022 Toyota Corolla 6 Speed Manual Transmission cars are affected. The slave cylinder is a defective part that fails prematurely anywhere between the 20,000-70,000 mile range. The slave cylinder on this car is made out of plastic and is located inside of the transmission, when the slave cylinder fails, it leaks brake fluid all over causing the car to lock into gear and not be able to shift which is a major safety risk when there is no signs of failure. My car locked up in the middle of a busy highway and had to be pushed off the side of the road. Not only is this a safety risk, but since the part is located inside of the transmission, which is not normal, it leaks brake fluid all over the clutch and flywheel, which will all need replacement. The dealership quotes between 4-5 thousand dollars to repair, and is not covered under warranty. Toyota knows that this part is a defective part because the new models received an updated slave cylinder made out of metal, rather than plastic, but no cars have been recalled. The car was towed to my local dealership and it is currently being worked on. The incident was reported to Toyota Corporate and a case was opened to investigate this issue. Every single model made between those years are effected and has caused thousands of people to be left with an expensive repair that is unavoidable.

I believe the break booster on my 2019 Toyota Corolla is defective. This caused my stopping distance to increase significantly, making it difficult to control my vehicle and putting myself and other drivers at risk. There were no warning lamps or messages or other symptoms prior to the start of the issue on October 10, 2025. I quickly took my car to a local mechanic the next day who said I had an issue with my brake booster. To make sure this was the issue I followed up and went to a Toyota dealership for a diagnostic. They initially told me that "all brake systems components were functioning normally at this time" and that all I need to do was to change the break fluid. I did this, but the problem persisted. I then returned to the Toyota dealership for a second diagnostic. This time they noted that the brake master cylinder and brake booster are loosing pressure internally and need to be replaced. When I googled this I saw that some 2019 Corolla (and other hybrid) vehicles were included in a 2019 recall for a brake booster pump that could fail, leading to a loss of braking assist, similar to what I was experiencing. I brought this up with the Toyota brand engagement center. They said there was no recall at this time on file, but that they would put me in touch with a representative who would manage my case (case # 251015000598). The representative would not pick up my phone calls. I was not able to speak with him. After many calls, a different representative spoke with me and told me that the case was already closed and that the assigned representative said he had explained to me why. This is not true as I had not had the chance to speak with him. I am concerned that Toyota has not given my break booster pump due diligence and is dismissing my legitimate safety concern and I would like to report this safety problem to the NHTSA.