1989 Mazda 323

Component: SEAT BELTS:FRONT:BUCKLE ASSEMBLY

THE FRONT SAFETY BELT BUCKLE RELEASE BUTTONS CAN BREAK. THESE RED PLASTIC RELEASE BUTTONS ARE MARKED "PRESS." IF A BUTTON BREAKS, PIECES CAN FALL INTO THE BUCKLE ASSEMBLY CAUSING THE BUCKLE TO OPERATE IMPROPERLY.

Consequence: THE SAFETY BELTS WOULD NOT PROVIDE ADEQUATE PROTECTION TO AN OCCUPANT IN A VEHICLE CRASH.

Remedy: OWNERS SHOULD PROMPTLY CHECK THE CONDITION AND OPERATION OF BOTH FRONT SAFETY BELT BUCKLES AND CAREFULLY INSPECT THE RED RELEASE BUTTON FOR ANY BREAKS OR CRACKS. THEY SHOULD ENSURE THAT BOTH BUCKLES ARE OPERATING PROPERLY BY INSERTING EACH LATCH PLATE INTO ITS BUCKLE, TUGGING ON THE BELT TO MAKE SURE THE LATCH IS SECURELY LOCKED, AND THEN PRESSING THE RELEASE BUTTON. THE LATCH PLATE SHOULD POP OUT OF THE BUCKLE WHEN THE BUTTON IS PRESSED. IF EITHER RELEASE BUTTON SHOWS A SIGN OF BREAKING OR CRACKING OR IF EITHER BUCKLE FAILS TO OPERATE PROPERLY, OWNERS SHOULD PROMPTLY CONTACT THEIR AUTHORIZED DEALER TO SCHEDULE AN APPOINTMENT TO HAVE THE BUCKLE REPLACED OR REPAIRED, FREE OF CHARGE. THE MANUFACTURER IS DEVELOPING A REMEDY DESIGNED TO PREVENT FAILURE OF THE BUTTONS THAT ARE NOT CURRENTLY BROKEN.

THE ALTERNATOR QUIT WHICH CAUSED THE COOLING FAN TO STOP , THE HEAT LIGHT DIDNT COME ON SO THE CAR RAN HOT AND EXPLODED THE RADIATOR, THE TOP OF THE RADIATOR CRACKED AND SPEWED OUT ALL OF THE WATER , THE BRAKES FAILED TWICE AND HAD TO REPLACE THE MASTER CYLINDER AND REAR BRAKES ,

MECHANIC WAS INFORMED BY MAZDA TO CAREFULLY OBSERVE BELT TENSION. MECHANIC FEELS THAT MAZDA'S DESIGN ON THE CRANKSHAFT HAS TOO LITTLE METAL LEFT AFTER THE FRONT JOUNAL TO PROVIDE ADEQUATE STRENGTH FOR CRANK NOT TO BREAK OVER LONG PERIOD OF TIME. CRANKSHAFT IS CUT DOWN A LOT FROM THE JOURNAL SIZE. MECHANIC NOTED THAT MAZDA HAS A SERVICE BULLENTIN IN REFERENCE TO ACCESORY BELT TENSIONS AND FEELS THAT MAZDA IS NOT WANTING TO ADMIT THAT CRANKSHAFT IS TOO SMALL. DIAMETER OF SHAFT LENDS ITSELF TO PERMATURE FAILURE DUE TO METAL FATIGUE. MECHANIC NOTED OTHER REPORTS ON NHTSA WEBSITE IN REFERENCE TO THIS PROBLEM. FELT NOTICE NEEDS TO BE OUT THERE. PROPERLY SIZED CRANKSHAFTS WITH PROPER LUBRICATION DO NOT BREAK. THEY ARE REUSED IN MOTOR CORES FOR REBUILDING. THIS RESULTED IN A PURCHASE OF A NEW ENGINE, NOT A REBULIT, FROM MAZDA.*AK

RIGHT/LEFT TIRES ARE JERKING REAL BAD WHEN TRAVELING AT ABOUT 60 MPH. *AK

WHILE DRIVING AT 50 MPH THERE IS VIBRATION WITHIN THE STEEING WHEEL AND THE STEERING IS OFF CENTER. *AK