NHTSA recalls, safety ratings, and consumer complaints for the 2020 Hyundai Kona.
| Overall Rating | |
| Frontal Crash | |
| Side Crash | |
| Rollover |
| Overall Rating | |
| Frontal Crash |
Component: ENGINE
Hyundai Motor America (Hyundai) is recalling certain 2019-2020 Elantra, 2019-2021 Kona and Veloster vehicles equipped with 2.0L Nu MPI engines. The piston oil rings may not have been properly heat-treated, which could result in engine damage.
Consequence: A damaged engine may stall, increasing the risk of a crash. In addition, oil may leak onto hot exhaust components, increasing the risk of a fire.
Remedy: Dealers will inspect and, if necessary, replace the engine, free of charge. In addition, Hyundai will deploy Piston Ring Noise Sensing System (PNSS) software. Owner notification letters were mailed August 24, 2021. Owners may contact Hyundai customer service at 1-855-371-9460.
Component: EQUIPMENT:OTHER:LABELS
Hyundai Motor America (Hyundai) is recalling certain 2020 Kona vehicles. The certification label may indicate incorrect Gross Axle Weight Rating (GAWR). As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) numbers 567, "Certification" and 110, "Tire Selection and Rims."
Consequence: An incorrect GAWR could result in the vehicle being overloaded, increasing the risk of a crash.
Remedy: Hyundai will notify owners, and dealers will install new label stickers displaying the correct GAWR over the affected areas of the certification label, free of charge. The recall began March 2, 2020. Owners may contact Hyundai customer service at 1-855-371-9460. Hyundai's number for this recall is 187.
The contact owns a 2020 Hyundai Kona. The contact stated that during a regular maintenance visit, the contact was informed that there was a leak coming from the front axle transfer case, which was initially unrepaired. The vehicle was subsequently taken to a dealer in Colorado, where the seal was replaced. However, while an oil change service was being performed later, it was discovered that the failure recurred because the previous repair was performed incorrectly. The first failure was for an inoperable seal, and the second failure was due to an improper repair. The third inspection confirmed that the seal had not been installed correctly during the prior service. The dealer was notified of the failure. The vehicle was not repaired. The manufacturer was notified of the failure. The failure mileage was 146,000.
Basically normal driving the car stalled. It slowed to a stall. I had to restart the car. This has happened a couple to times.
On 3/29/26 my Kona caught fire while parked in the front left side of the engine and burned completely within eight minutes. This is not an electric car. Prior to that I drove the car all day with no incident. It was later in the evening around 5:40 PM. I had driven from my house to a restaurant which is about 6.8 miles from my house. I parked my car and then my son-in-law noticed that my engine was smoking. My husband went to check to see if it was the radiator, but he noticed that it was fire and we called [XXX] . I know there are no recalls for my car, but I wanted to report it to you. The car only had 44,900 miles on it and was only serviced by West Nyack Hyundai. The last service was on 1/19/26. If you have any questions, you can email me at [XXX] INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)
The 2020 Hyundai Kona has 2 NHTSA recalls and 143 consumer complaints on file. It received an overall safety rating of 5 out of 5 stars in NHTSA crash testing. The high number of complaints suggests potential reliability concerns — review the complaint details above before purchasing. For the most detailed information about a specific vehicle, decode its VIN using our free decoder above.
Enter a specific VIN to get the full report — specs, recalls, safety ratings, complaints, investigations, and technical service bulletins.
| Side Crash |
| Rollover |
My car was taken in as a part of recall bulletin 203 for improperly heated piston rings treated pistons rings that result in premature engine failure and possible fire on 12/5/25. The knock sensor test was performed and the KSDS software was installed. On 3/12/26 my daughter who was on the way home from a trip called because her checking engine light started flashing and the engine was knocking. We had it towed to Hyundai and they are denying service under the recall stating improper codes yet one of the codes is P1327 KSDS detection which is related to the rod bearing failure the car currently has. They are trying to make me pay $4600 out of pocket plus the tow bill when this is directly related to the recall.
My 2020 Hyundai Kona (VIN: [XXX] ) has a persistent engine stalling safety defect that matches Recall 203 (22-01-042H, NHTSA Campaign 21V301000 – Nu 2.0L Atkinson Engine Inspection and Replacement). The recall addresses improperly heat-treated piston oil rings causing cylinder bore scuffing, accelerated oil consumption, abnormal knocking, and potential engine stall while driving (increasing crash/fire risk).I first brought the vehicle to Corona Hyundai for repeated stalling while driving. They performed the recall vibration inspection and software update (Campaign 974), stated the test passed, and declared the vehicle "fixed", safe and "good-to-go" Immediately after pickup, the stalling returned worse: approximately 60-80 miles later on XX near the XXX exit (four-lane high-speed highway), the engine completely stalled at 65 mph while merging for an exit. This caused vehicles and semi-trucks behind me to swerve dangerously and very nearly collide with me. The vehicle stalled four more times on the way to my destination in [XXX] .I then took it to the nearest dealer, Carlsbad Hyundai for safety reasons. They performed the vibration inspection again, which also "passed," yet the real-world symptoms would continue unchanged: accelerated oil consumption (I monitor the dipstick and refill regularly), sputtering, knocking noises, and complete engine stalls (dozens of incidents, especially on local roads and turns). The vehicle remains undrivable due to imminent stall risk while moving and putting myself, my passengers and other commuters at high risk of severe injury or death.Both dealers and Hyundai Customer Care (Case #XXX) have refused further action, stating the vibration test passed, they cannot duplicate the concern, and no additional claim can be submitted for engine replacement. Hyundai's TSB [XXX] requires only the vibration inspection; engine replacement is authorized if "NO PASS" – no separate oil consumption test or monitored drive INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)
The contact owns a 2020 Hyundai Kona. While the contact’s son was driving the vehicle on the highway at an undisclosed speed, there was a knocking sound coming from the engine and the vehicle failed to stop as intended. The gear shifter was shifted into neutral(N) and restarted; however, the engine failed shortly afterwards, and the vehicle was unable to restart. No warning lights were illuminated. The vehicle was towed to an independent mechanic, where it was diagnosed with piston rings failure and low engine oil. The vehicle was not repaired. The manufacturer was notified of the failure, where it was confirmed that the VIN was included in NHTSA Campaign Number: 21V301000 (Engine); however, the recall repair was already performed. The approximate failure mileage was 108,000.
many times a year, without warning, vehicle dash lights turn off and light up like a christmas tree, followed by fca warning sound and lights going off, and a loud mechanical thud. Lose engine throttle going highway speeds. This can occur at nearly any speed without warning. Car must be powered off and back on to get normalcy. This puts me, everyone in the car and everyone on the highway at risk. Dealership was not able to reproduce or pull error codes.
While driving under normal conditions, the vehicle’s dual-clutch transmission (DCT) failed to engage properly, causing a sudden and unexpected loss of propulsion. When the accelerator was pressed, the vehicle hesitated and did not respond as commanded, resulting in delayed or no acceleration. This occurred while driving in traffic at approximately 30 mph while trying to acceletate to merge onto highway and has happened multiple times. In some instances, the vehicle appeared to remain in gear but would not accelerate, and in other instances the transmission disengaged before re-engaging unpredictably. This created an unsafe situation, as the vehicle could not maintain speed or merge safely, significantly increasing the risk of a collision, especially in traffic or at intersections. The issue occurred without sufficient warning and continues to happen intermittently during normal driving.The vehicle was inspected by a dealership, which stated the condition is related to a clutch issue within the dual-clutch transmission and acknowledged it is a known issue affecting this transmission. The dealership further stated the issue would not be repaired because the vehicle is out of warranty.
the headlights in this model Kona keep burning out after 9 months or so. I have replaced them multiple times in the last 5 years on both left and right sides. I use glove to put in the bulbs and are very careful not to let my hands touch the bulb. I have never had this happen with any other car I have owned. I suspect an electrical system issue, or perhaps wiring, but that is speculation. I have not had this inspected by the dealership. The latest date of failure is listed below.
The timing system was repaired in February 2025. After similar symptoms of vehicle stalling, the check engine light came on Found a software update that needed to be completed to determine if engine needed replaced. Dealership has refused for seven weeks to complete the entire job of the update which includes running a diagnostic of codes. Instead, they have been arguing that the timing system needs replaced and not providing the codes from the safety software update. Obviously there's a much deeper issue if the timing system keeps breaking down.
Vehicle suddenly began shutting off upon braking and/or acceleration at any speed, idling very hard, and/or barely starting or dying immediately after starting and making a very loud whining noise while driving on an interstate. A mechanic ran a diagnostic test on it and determined that it was a P1327 code and recommended it be taken to dealership for full engine failure. This particular code was known by Hyundai to occur on certain models and years, including Kona 2019-2021, as early as 2022 and while a recall campaign was initiated, no recall to date has been issued. No warning indicators on dash occurred in advance or even after the vehicle began malfunctioning (i.e., no check engine indicator, etc.). Vehicle is available at dealership upon request.
The vehicle has ~51K miles. It has been maintained according to the manufacturer's recommended repair schedule. At low speeds (<10 mph) or when coming from a full stop the vehicle hard shifts. When driving up inclines at low speeds (<10 mph), the vehicle shakes and stutters on the verge of shutting off. This happened twice on [XXX]. I experienced a full vehicle shut off on [XXX} while the vehicle was stationary, but shifted into drive . In August, the vehicle stuttered and shook before shutting off. I have reported three instances of this issue to my local Hyundai dealership. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)
The engine shut down when the car stops at a red light or stop sign. There are metal shavings in the oil due to issues with the pistons.
Car keeps stalling no matter what speed you're driving. Took the car to NTB and they said nothing is wrong with it. It continues to happen even in busy highways where someone almost ran into the back of me. Not safe to drive. Concerned as numerous forums suggest this is a problem with 2019-2021 Hyundai Konas.
The contact owns a 2020 Hyundai Kona. The contact stated that the vehicle was consuming an excessive amount of engine oil. There was no warning light illuminated. The vehicle was taken to a local dealer, where the vehicle was diagnosed, and the contact was informed that the turbocharger was faulty and needed to be replaced. The vehicle was not repaired. The manufacturer was notified of the failure. The approximate failure mileage was 65,000.
Showing 15 of 143 complaints