2017 Honda Ridgeline

The car engine stalled on highway and was not able to stall. Mechanic shop checked the car, and told me that the problem is a seized engine.

Problem: Engine rod knock that could be related to open investigation NHTSA CAMPAIGN NUMBER: PE25008 The vehicle is available for inspection. Risks: Engine stall, loss of power, fire, or total engine failure. The rod knock is reproduced every time the engine is started. It has not been confirmed by a dealership or independent service center. The vehicle has not been inspected by the manufacturer, police, insurance representatives or others. There were no warning, lamps or messages of the problem prior to the failure. It just started at some point mid November. I have not driven the vehicle since.

The dealership has advised replacing the transmission at a cost of $11,937.77 following diagnostic code P0776 (A/T Clutch Pressure Control Solenoid Valve B Stuck Off). I believe this expense should not fall entirely on me for the following reasons: • Honda has a documented history of transmission and torque‑converter‑related issues on the 2017–2019 Ridgeline. Honda Service Bulletin 23‑078 extends warranty coverage to 8 years/150,000 miles for torque‑converter failures associated with DTC P0741. My vehicle has previously undergone multiple transmission‑related warranty repairs and software updates intended to address judder, slipping, and torque‑converter concerns (referenced in earlier service records at 39,678 miles and during warranty-extension procedures). • My service history shows consistent dealer maintenance and multiple prior transmission‑related interventions. The attached service records reflect that I have followed Honda’s recommended maintenance schedule and have repeatedly brought the vehicle to Honda dealerships for all inspections, fluid services, and software updates. The dealership has also previously documented transmission judder and performed warranty-related ATF flushes and software updates intended to correct torque‑converter and clutch‑pressure issues. • The current failure appears related to long‑term degradation of the same transmission systems Honda has acknowledged as problematic. Although the stored DTC is P0776 rather than P0741, both faults relate to clutch‑pressure control and hydraulic operation within the 6‑speed automatic transmission. These problems are highly consistent with the known failures described in Honda’s own bulletin and with my vehicle’s earlier symptoms recorded by Honda technicians—specifically hard shifting, juddering, and slipping under load. • A nearly $12,000 repair on a well‑maintained Honda with documented history of related issues is unreasonable for the customer to absorb entirely.

When driving the vehicle on I-94 near Taylor, MI, 2 codes popped up on my dashboard cluster: 1) Transmission System Problem 2) Blind Spot Info System Problem When diagnosing this at a local auto stores & the Honda dealer itself, a stored code of DTC P0741 Torque Converter Clutch Circuit Performance or Stuck OFF is listed. Honda has identified a problem with this under Service Bulletin 23-078, but after talking with the dealer & calling American Honda they state the issue does not relate to my vehicle, even though it falls under their 2017-2019 Honda Ridgeline model.. The model in question is a 2017 Honda Ridgeline Black Edition. American Honda is not taking ownership of the same issue as described in their bulletin stating improper specifications when manufactured.

The contact owns a 2017 Honda Ridgeline. The contact stated that while starting and driving the vehicle, the driver became aware that the engine was knocking. The vehicle was driven to a local dealer, where it was diagnosed, and the failure was associated with NHTSA Campaign Number: 23V751000 (ENGINE AND ENGINE COOLING); however, the VIN was not included in the recall. The vehicle was not repaired. The manufacturer was notified of the failure. The failure mileage was 90,000.

I had went to the store which is about 3 minutes from my house and on the way back my truck started running hot all of a sudden we were almost home and it was boiling hot from the temperature gauge we pulled in we get out and we look and my vehicle is pouring antifreeze out so my partner looked and he thought it was the crush washer and bolt he replaced the crush washer we drove to Morganton NC but it wasn't the engine actually had a hole in it and the antifreeze was pouring out of the engine there is a hole in it behind the drain plug there is no reason they should even be a hole in it I only have 64,000 miles on it it's been very well taken care of and I know that there is an investigation going on on these vehicles between 2017 to 2019 on the Honda ridgelines I drive to working back I work the most 6 miles from my house text me not even 5 minutes to get to work and then I'll leave the office and it takes me about 5 more minutes to get to the place I'm going cuz I work with hospice but for my vehicle just to start overheating for no reason pull in the driveway moments later and there's a big hole in it there's something bad wrong and I need help with this I'm in healthcare and I have to have my vehicle I've not had this vehicle but about 2 years and I'm paying on it it's like it's corroded from the inside out I guess you could say!

At 96k miles, the transmission started slipping and juddering. Three warnings appeared: transmission system, emission system, and blind-spot monitoring problems. Also P-D indicator flashing to not drive. Took into dealership. They said that code P0776 was appearing - clogged solenoid in the transmission. Also said that transmission fluid had a foul burnt smell and had large pieces of the clutch. All of these are symptoms of the torque converter failure, which is covered under TSB 23-078 with warranty extension to 10 years, 150 k miles in letter of June 2025. The TSB states that the warranty will only cover these problems if code P0741 appears. Visually, the dealership has confirmed that my torque converter has failed and my transmission needs replacing. However, because code P0741 isn't showing up, they will not cover replacement. Also they confirmed that the clogged solenoid was due to the failed torque converter. They are fixated on the code reading and refuse to repair the transmission. They quoted me a price of over $13,000 to do this work. The TSB 23-078 should have included any code associated with the transmission, torque converter, or other transmission components such as the solenoid B that would be affected by the failed torque converter.

To Whom It May Concern: I am submitting this complaint to report what I believe to be a potential safety-related defect in my Honda vehicle, as well as an unresolved dispute with American Honda regarding responsibility for resulting damage. Recently, I was informed by my case manager at American Honda that my claim had been closed and that Honda would not cover the necessary repairs. When I requested an opportunity to escalate the matter, I was told that no escalation was available. I am seeking NHTSA’s review because the circumstances involve component failures that may affect vehicle emissions, performance, and potentially safety. The fuel injectors in my vehicle failed,this failure caused the catalytic converter to become damaged, andHonda accepted responsibility for the faulty fuel injectors. Honda has refused to cover the damage to the catalytic converter. Because the catalytic converter failure was reportedly caused by faulty fuel injectors—components for which Honda accepted responsibility—I believe the manufacturer should cover all resulting damage, regardless of warranty status. I request that the National Highway Traffic Safety Administration: Investigate whether similar fuel injector failures are occurring in Honda vehicles. Review whether these failures are causing catalytic converter or other engine damage. Determine whether the manufacturer is appropriately addressing these failures.

75k miles on the engine, routine 5k oil change intervals, rod bearing failure.

The engine in my 2017 Honda Ridgeline started making an unusual noise coming from the engine. My mechanic completed testing and said that the piston rod bearing was failing. He suggested taking into the Honda dealer and they also confirmed it was the piston rod. The VIN was apparently not included the current recall so they suggested that we replace the motor. It is unclear why all the engines weren't recalled but there is obviously a problem with Ridgelines not included in the recall. My mechanic indicated that it is a safety problem when the piston rod fails. He also indicated that it's just a matter of time until it fails..

Driving down the highway road I lost full power and the engine made a bad knocking sound when the gas pedal was pressed. It is at the dealership they stated there was metal in the oil and stated the bearings wore out. No warning lights while driving. It has approximately 72,000 miles. I was able to control the vehicle, but could not drive it far. Going uphill it could not travel at the same speed as traffic. That put my safety at risk one, because it caused others to slow down, two I was in a remote part of the state by myself if it stopped altogether I would have been stranded.

Engine failure at 95,000 miles due to connecting rod bearing failure. Honda Dealer has replaced engine with new short block. Engine was making a knocking noise during acceleration. Removal of the oil pan revealed a failed rod bearing on one cylinder and a discolored bearing on a second.