10 NHTSA recall campaigns have been issued for the 2007 Volvo Vhd. Click any campaign to view full defect, consequence, and remedy details.
Component: EXTERIOR LIGHTING
Volvo Trucks North America (Volvo) is recalling certain 2004-2019 Volvo VHD trucks equipped with snow plow lamp preparation kits. The snow plow headlights can be turned on without other exterior lights, and high beam indicator will not work when the snow plow high beams are on. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) number 108, "Lamps, Reflective Devices, and Associated Equipment."
Consequence: The driver may operate the vehicle with the snow plow headlights on but the marker and tail lamps off, reducing the vehicle's
visibility and increasing the risk of a crash.
Full recall detail →
Component: SEAT BELTS
Volvo is recalling certain model year 2002-2013 VHD and VN trucks, manufactured from August 4, 2000, through June 22, 2012, and equipped with bench passenger seats. The seat belt d-ring weld may not be sufficient enough to meet the seat belt pull test. Therefore, these vehicles fail to conform to the requirements of Federal Motor Vehicle Safety Standard No. 210, "Seat Belt Assembly Anchorages."
Consequence: In the event of a crash, an insufficient seat belt weld may prevent the seat belt from properly restraining the occupant. This increases the risk of injury to the seat occupant.
Full recall detail →
Component: POWER TRAIN:CLUTCH ASSEMBLY
Volvo Trucks North America (Volvo) is recalling certain model year 2007-2014 VAH, VHD, VNL, VNM, and VT models. The affected vehicles were built without a redundant clutch disengagement switch. Without a redundant switch, a loss of signal from the brake air pressure switch can prevent the clutch from automatically disengaging when the brake is applied.
Consequence: Without a signal to disengage the clutch when the brakes are applied, the distance required to stop the truck may lengthen, increasing the risk of a crash.
Full recall detail →
Component: SERVICE BRAKES, AIR:SUPPLY:QUICK RELEASE VALVE
VOLVO TRUCKS IS RECALLING CERTAIN MODEL YEAR 2007 AND 2009 VHD, MODEL YEAR 2006 THROUGH 2010 VN, AND MODEL YEAR 2007 THROUGH 2009 VT TRUCKS MANUFACTURED FROM NOVEMBER 7, 2005, THROUGH OCTOBER 30, 2009, EQUIPPED WITH AN AIR RELEASE FIFTH WHEEL. THE INVERSION VALVE ON THE FRAME MAY BE ORIENTATED WHERE CONTAMINANTS CAN ENTER THE VALVE THROUGH THE EXHAUST PORT. AS A RESULT, THE BRAKE VALVE MAY CORRODE.
Consequence: CORROSION OF THE VALVE CAN CAUSE IT TO MALFUNCTION, THEREBY ADVERSELY AFFECTING BRAKING PERFORMANCE AND INCREASING THE RISK OF A CRASH.
Full recall detail →
Component: VISIBILITY:WINDSHIELD WIPER/WASHER:MOTOR
VOLVO TRUCKS IS RECALLING 127,764 MY 2001-2008 VHD, VNL, VNM, AND MY 2005-2008 VT TRUCKS. A SEAL MAY FAIL ALLOWING WATER AND CONTAMINANTS TO SEEP INTO THE WINDSHIELD WIPER MOTOR.
Consequence: IF THIS HAPPENS A SHORT CIRCUIT MAY OCCUR, WHICH OVER TIME COULD POSSIBLY LEAD TO A VEHICLE FIRE.
Full recall detail →
Component: STEERING:GEAR BOX:SHAFT SECTOR
ON CERTAIN HEAVY DUTY CLASS 8 TRUCKS EQUIPPED WITH DANA STEERING SHAFTS, THERE IS A POTENTIAL THAT THE STEERING SHAFT PINCH BOLT HOLE MAY BE INCORRECTLY LOCATED. THE PINCH BOLT FITS INTO A GROOVE IN THE STEERING GEAR INPUT SHAFT TO ENSURE THAT THE STEERING SHAFT DOES NOT SEPARATE FROM THE STEERING GEAR IF THE PINCH BOLT COMES LOOSE.
Consequence: THIS COULD POTENTIALLY LEAD TO STEERING SHAFT SEPARATION RESULTING IN LOSS OF CONTROL OF THE VEHICLE IF THE PINCH BOLT WERE TO COME LOOSE INCREASING THE RISK OF A CRASH.
Full recall detail →
Component: FUEL SYSTEM, DIESEL
ON CERTAIN TRUCKS, AN UNPROTECTED LEAD IN THE THERMOSWITCH OF THE HEATER MAY MAKE CONTACT WITH ANOTHER POST POSSIBLY CREATING A SHORT CIRCUIT, WHICH CAN RESULT IN CONTINUOUS OPERATION OF THE HEATING ELEMENT.
Consequence: IF THE CONDITION EXISTS AND THE KEY IS LEFT ON WITHOUT FUEL IN THE FILTER, THE HEATING ELEMENT MAY HEAT TO A POINT WHERE A FLAME BECOMES PRESENT AT THE TIP OF THE ELEMENT WHICH COULD RESULT IN A VEHICLE FIRE.
Full recall detail →
Component: TRAILER HITCHES:FIFTH WHEEL ASSEMBLY
ON CERTAIN TRUCKS EQUIPPED WITH A SAF HOLLAND SIMPLEX FIFTH WHEEL, THE LEVER ARM PIVOT BOLT MAY HAVE BEEN OVER TIGHTENED. AN OVER TIGHTENED PIVOT BOLT CAN DISTORT THE PIVOT BOLT SPACER SLEEVE, WHICH MAY PREVENT THE FIFTH WHEEL LATCH JAW FROM CLOSING AND LATCHING SECURELY AROUND THE TRAILER KING PIN.
Consequence: THERE IS A POSSIBILITY THAT THE PIVOT BOLT CAN BECOME LOOSE WITHOUT THE DRIVER'S KNOWLEDGE. WHEN THIS OCCURS, THE DRIVER COULD DRIVE AWAY AND THE TRAILER COULD BECOME DISENGAGED, INCREASING THE RISK OF A CRASH.
Full recall detail →
Component: STEERING
ON CERTAIN TRUCKS, THE NUT USED TO RETAIN THE STEERING SHAFT MAY OR MAY NOT BE A LOCK NUT THAT HAS THE LOCKING FEATURE. A LOCK NUT IS REQUIRED TO PROVIDE ADDITIONAL RESISTANCE TO ENSURE THAT THE NUT DOES NOT COME LOOSE.
Consequence: IF THE NUT WERE TO COME LOOSE, THE STEERING SHAFT COULD POTENTIALLY SEPARATE RESULTING IN LOSS OF STEERING CONTROL WHICH COULD CAUSE A CRASH.
Full recall detail →
Component: ELECTRICAL SYSTEM:WIRING:FUSES AND CIRCUIT BREAKERS
ON CERTAIN HEAVY DUTY TRUCKS, THE CIRCUIT PROTECTION (I.E. AUTOMATIC CIRCUIT BREAKERS) USED TO PROTECT THE VEHICLE LIGHTING SYSTEM MAY NOT PROVIDE ADEQUATE PROTECTION.
Consequence: IF A SHORT CIRCUIT OCCURS AND IS LEFT UNTREATED, COMPONENTS AND WIRING MAY BE SUBJECT TO OVERHEATING WHICH COULD POSSIBLY RESULT IN A VEHICLE FIRE.
Full recall detail →