2003 Mazda MPV Recalls

Component: EQUIPMENT:OTHER:LABELS

CERTAIN MINIVANS FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 208, "OCCUPANT CRASH PROTECTION." SOME OF THESE VEHICLES WERE PRODUCED WITH AIR BAG WARNING LABELS INTENDED FOR THE CANADIAN MARKET. THUS, THE LABELS CONTAIN WARNINGS IN BOTH ENGLISH AND FRENCH. AS A RESULT, THE AREA OF THE ENGLISH WARNING IS ONLY 16 SQUARE CENTIMETERS, AS OPPOSED TO THE 30 SQUARE CENTIMETERS REQUIRED BY THE STANDARD.

Full recall detail →

Component: EXTERIOR LIGHTING:FOG LIGHTS

ON CERTAIN MINI VANS AND PASSENGER VEHICLES, THE SOCKET HOLDER IN THE FOG LIGHTS IS INSTALLED IN THE LAMP CASING USING PRESSURE. DURING OPERATION OF THE FOG LIGHT, THE HEAT FROM THE BULB CAN EXPAND THE SOCKET HOLDER. THE EXPANSION CAN FORCE THE SOCKET HOLDER REARWARD. AFTER REPEATEDLY BEING SUBJECT TO THIS EXPANSION, IF THE FOG LIGHT IS ALSO SUBJECTED TO VIBRATION DURING VEHICLE OPERATION, THE SOCKET HOLDER WITH THE BULB HOLDER AND THE WIRING HARNESS MAY SEPARATE FROM THE FOG LIGHT CASING.

Consequence: SHOULD THIS OCCUR, THE BULB SOCKET AND THE HARNESS CAN DROP INSIDE THE BUMPER AND POSSIBLY BUT RARELY, THE HEAT GENERATED BY THE BULB CAN CAUSE THE BUMPER TO BURN.

Full recall detail →

Component: EQUIPMENT:OTHER:LABELS

THE TIRE INFLATION PRESSURE INDICATED ON THE VEHICLE CERTIFICATION LABEL IS NOT CORRECT. THE LABELS SHOW THE MAXIMUM TIRE PRESSURE AS 240 KPA/32 PSI WHEN IT SHOULD BE SHOWN AS 240 KPA/35 PSI. AS A RESULT OF THIS ERROR, THE LOAD RATIOS FOR THE 205/65R15 94H AND THE 215/60R16 95H TIRES EXCEED THE LEVELS PERMITTED BY FMVSS 120.

Consequence: IF THE TIRE IS OPERATED IN AN UNDER-INFLATED CONDITION, THE LOAD CARRYING CAPACITY OF THE VEHICLE MAY BE COMPROMISED, INCREASING THE RISK OF A CRASH.

Full recall detail →

Component: EXTERIOR LIGHTING:FOG LIGHTS

ON CERTAIN MINI VANS EQUIPPED WITH FRONT FOG LIGHTS,THE FOG LIGHT BULB SOCKET MAY HAVE BEEN INSTALLED IMPROPERLY.

Consequence: IF THE VEHICLE CONTINUES TO BE USED WITH THIS CONDITION, THE BULB SOCKET AND THE WIRING HARNESS MAY SEPARATE FROM THE FOG LIGHT HOUSING IF EXPOSED TO SHOCK AND/OR VIBRATION AND DROP INSIDE THE BUMPER. SHOULD THIS OCCUR, THE OPERATION OF THE FOG LIGHT MAY THEN CAUSE THE BUMPER TO BURN.

Full recall detail →